NX2027 - Is there a fix or is this a Glitch

[Kenja824]

We are sometimes having an issue where we can extract edges in modeling, and then do a "Save View As". Then when we place the new view in drafting all of the lines disappear. To get them to show up in the drafting view, we have to go back to modeling and select all the lines, and cut and paste the lines.

Recently someone had a different but similar issue. They will create the view, when they go to add the view in drafting, the Preview will not show the lines but when he places the view they show up. But the lines that show up are selectable in drafting and don't seem connected to modeling. When you delete one of the lines in drafting, even though it is in the view, it acts as if the line was created inside the drafting view. It deletes with no warning that you are deleting a modeling object.

I found however if we go into modeling and select all the lines and cut and paste them again. Everything works right. Just like the other issue.


It is almost like some workers are doing their work in a dream state and have to cut their work out of the dream state and paste it into reality. lol

Does anyone else have a similar issue or know what the fix is?