Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX11 basic curves

Status
Not open for further replies.

4square

Automotive
Dec 8, 2014
1
Is Siemens officially, once and for all, removing the Basic Curves functionality from NX? Ihave heard this but I still can launch Basic Curves with command finder.
Just wondering, perhaps the KEEP IT public sentiment was heard? :)
 
Replies continue below

Recommended for you

It's rare that ANYTHING is totally removed. Granted, they may make it harder to find so as to keep it away from the newbies, but if you look hard enough, you can still generally find the older, albeit now undocumented and less likely to be maintained, functions, as you've already demonstrated. But if you DO SEE some sort of notice, either in the Release Notes or the documentation, that something is on the bubble, as it were, for elimination, then it's just a matter of time, but even then we're generally talking at least two and perhaps three releases before the final curtain comes-down on it.

John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:

The secret of life is not finding someone to live with
It's finding someone you can't live without
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor