Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nozzle pad

Status
Not open for further replies.
Amanda123

Amanda123

Petroleum
Joined
Feb 7, 2018
Messages
26
Location
MY
Hello, everybody here,

How to we determine if a nozzle pad require for vessel? and if required how to calculate the pad size? Any comments are appreciated.
 
Sort by date Sort by votes
Your calculations will determine whether or not your nozzle needs a repad to meet the Code requirements openings. Review the appropriate section of ASME VIII Div 1.
 
Upvote 0 Downvote
or other (unspecified) Code of Construction.

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Assuming that it is an ASME VIII, Div. 1 construction, please read UG-37 and Figure UG-37.1.
 
Upvote 0 Downvote
Refer UG-36, UG-37 & UG-40 of ASME SEC VIII DIV 1.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Vessel-SA
  • Question Question
nozzle-head PWHT
Replies
14
Views
15K
Trestala
Trestala
Sajjad2164
  • Question Question
ASME VIII-1 Nozzle Spacing Clash
Replies
7
Views
11K
Si-bo
Si-bo
dbday
  • Locked
  • Question Question
Nozzle bore machining
Replies
5
Views
2K
r6155
r6155
IdanPV
  • Locked
  • Question Question
Nozzle to Shell Weld
Replies
11
Views
5K
DekDee
DekDee
RadiateurFou
  • Question Question
Buckling analysis of header/nozzle assembly
Replies
2
Views
3K
RadiateurFou
RadiateurFou

Part and Inventory Search

Sponsor

Back
Top