Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nonlinear analysis using HyperMesh with OptiStruct

Status
Not open for further replies.
mohamed hassan 2014

mohamed hassan 2014

Structural
Joined
Dec 31, 2018
Messages
11
Location
FR
Hello,

Please, I am currently conducting a nonlinear analysis using HyperMesh with OptiStruct (NLPRAM and NLOUT), and it is taking a considerable amount of time. Therefore, I would like to stop the run and continue next week. Is it possible to stop the run and resume from the point where it stopped? If so, how can I do that?


Thank you.
 
Status
Not open for further replies.

Similar threads

Kamyar_K
  • Question Question
How to get uniform tension in a rail using dynamic/explicit analysis?
Replies
6
Views
9K
rb1957
rb1957
T
Thermal load with thermal gradient in a structure analysis with FEM
Replies
1
Views
399
SWComposites
SWComposites
Gardenfence
  • Locked
  • Question Question
CBUSH coincident nodes in hypermesh?
Replies
1
Views
2K
SWComposites
SWComposites
G
  • Question Question
FEA Simulation of a Piezoelectric Accelerometer with Frequency Response Analysis
Replies
2
Views
9K
gnana_235
G
Facundo L. Pfeffer
  • Locked
  • Question Question
Correct way to perform nonlinear buckling analysis
Replies
6
Views
2K
centondollar
centondollar

Part and Inventory Search

Sponsor

Back
Top