Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nonlinear analysis using HyperMesh with OptiStruct

Thread starter mohamed hassan 2014
Start date Aug 23, 2024

Status: Not open for further replies.

Aug 23, 2024

mohamed hassan 2014

Structural

Hello,

Please, I am currently conducting a nonlinear analysis using HyperMesh with OptiStruct (NLPRAM and NLOUT), and it is taking a considerable amount of time. Therefore, I would like to stop the run and continue next week. Is it possible to stop the run and resume from the point where it stopped? If so, how can I do that?

Thank you.