Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

No subassembly visible while importing motion load to CWD

Status
Not open for further replies.
riteshharishborikar

riteshharishborikar

Mechanical
Joined
Jun 15, 2007
Messages
9
Location
IN
Hi,

There are no subassem. visible whicle importing motion loads to designer, searching knowledge base found that it can only be imported for part and not for subassembly, try to flatten strusture of assembly due to this limitation.
How practical is this anybody given a try?

 
Status
Not open for further replies.

Similar threads

pllmoreau
  • Locked
  • Question Question
Solidworks Simulations Bearing Load error
Replies
4
Views
2K
pllmoreau
pllmoreau
samim09me
  • Locked
  • Question Question
How Solidworks Motion Analysis function builder are used with examples
Replies
0
Views
958
samim09me
samim09me
dlagr21
  • Locked
  • Question Question
How to fixture plate for stepping scenario
Replies
3
Views
1K
FEA way
FEA way
ElMicha
  • Locked
  • Question Question
How To Run FEA on Nut-Bolt Assembly
Replies
7
Views
1K
3DDave
3DDave
cobra46
  • Locked
  • Question Question
how to include damping in a shock study
Replies
5
Views
1K
statist1
statist1

Part and Inventory Search

Sponsor

Back
Top