Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need some advice

Status
Not open for further replies.
You could do a seperate cut-revolve at the abrupt end of the sweep in the "Bad Drill" example. That would simulate the cutter run-out.

[cheers]
Eng-Tips.com Forum Policies faq731-376
Making the best use of this Forum. faq559-716
How to get answers to your SW questions. faq559-1091
Helpful SW websites every user should be aware of. faq559-520
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top