Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need help interpreting this drawing feature control frame A, Is it right to refer the datum B in feature control frame to which it is attached?

You must log in or register to reply here.

Similar threads

F
  • Question Question
Use the Drawing title block linear tolerance to control a Diametrical callout size - is it correct?
Replies
3
Views
2K
Burunduk
Burunduk
jassco
  • Locked
  • Question Question
How to use profile of surface feature control frame to control max. protrusion?
Replies
15
Views
4K
mfgenggear
mfgenggear
C
  • Question Question
Symmetric to Centerline note is given to below drawing attached, need to understand how manufacturer will punch the holes at what tolerance.
Replies
16
Views
26K
Burunduk
Burunduk
Diametrix
  • Question Question
Hex hole as a datum feature
2
Replies
21
Views
22K
Burunduk
Burunduk
Ben K
  • Locked
  • Question Question
Feature Control Frame with Multiple Leaders (Angularity)
Replies
7
Views
1K
Doug Hunter
Doug Hunter

Part and Inventory Search

Sponsor

Back
Top