rudiklk
Automotive
- Jul 22, 2004
- 5
In the first run I acquire the Displacement, Oload and SPCForce from all Elements, Force and Stresses from Element Set 1 in Subcase 1 and SC 2.
Do I Restart and analyze a Subcase 3 after Subcase 1 (with param,loopid and param,subid) I get ALL the results only for the 1st load step of SC 3 and for all subsequent load steps only the forces and stresses.
Do I modify the Case Control Section for forces and stresses to ALL (means requesting all results for all elements) again in the op2 after the 1st load step there are only Force and Stress Results !?
How do I get also the Displacements, Oloads and SPCForces for all load steps?
Thanks for your help
Rudi
Do I Restart and analyze a Subcase 3 after Subcase 1 (with param,loopid and param,subid) I get ALL the results only for the 1st load step of SC 3 and for all subsequent load steps only the forces and stresses.
Do I modify the Case Control Section for forces and stresses to ALL (means requesting all results for all elements) again in the op2 after the 1st load step there are only Force and Stress Results !?
How do I get also the Displacements, Oloads and SPCForces for all load steps?
Thanks for your help
Rudi