Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Moment Curvature Analysis in SAP2000

Status
Not open for further replies.
maestri

maestri

Structural
Joined
Aug 4, 2013
Messages
7
Location
US
Is it possible to perform Moment Curvature analysis for a Prestressed Cross section in SAP2000?
 
Sort by date Sort by votes
Define or open your section in the SD Section Designer which can found under "Other" frame section type. The moment-curvature and strain-curvature values should change if you enter tension load or compressive load
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

StathPol12
  • Question Question
SAP2000 measurements
Replies
2
Views
6K
Luceid
Luceid
GJoeRMK
  • Question Question
A Sap2000 API question, SapObject.SapModel.SolidObj.AddByCoord()
Replies
2
Views
2K
GJoeRMK
GJoeRMK
Brad805
  • Locked
  • Question Question
SAP2000 Quick Plots
Replies
7
Views
2K
Brad805
Brad805
K
  • Question Question
C# SAP2000 API v26.2.0 - Load Patterns Not Appearing in "Load Pattern Definitions" Table Despite Being Created
Replies
0
Views
6K
keremsari
K
juandavidguzman
  • Locked
  • Question Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
2K
STpipe
STpipe

Part and Inventory Search

Sponsor

Back
Top