Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

modelling data for generators

Status
Not open for further replies.

anna8

Electrical
Joined
Sep 17, 2002
Messages
4
Location
GB
Where can I obtain detailed modelling data for fault and dynamic analysis for AC 1MW -5MW generators?

 
Manuf should provide. I have some generator dynamics for 5MW mach but no gov.
 
Here are some typical mean values:

Reactances
Type of Gen Subtransient Transient Steady-State
Turbogenerator 10-20% 15-25% 150-230%
Salient-pole gen. 15-25% 25-35% 70-120%

See the enclose document with typical sequence resistance and reactance for small generator


The enclose have some additional information that could be use thread237-27981

Good luck.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top