kammieorama
Automotive
- Dec 23, 2011
- 31
I am trying to run a SOL103 in NxNastran v 8.1.
In my model there is are Surface cards (BSURFS)
I have just mentioned BSURFS.
Now SOL103 is running error free but the parts on which i defined surfaces are not acting like surfaces.
I mean in the modal shapes i see them bend independent of each other.
I would like them to act as contacts (like in abaqus)
Is there any contact or surface parameter that i need to add to define the surface that should come in contact.
best regards
Kammieo
In my model there is are Surface cards (BSURFS)
I have just mentioned BSURFS.
Now SOL103 is running error free but the parts on which i defined surfaces are not acting like surfaces.
I mean in the modal shapes i see them bend independent of each other.
I would like them to act as contacts (like in abaqus)
Is there any contact or surface parameter that i need to add to define the surface that should come in contact.
best regards
Kammieo
