Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitsi to BACnet/LonWorks

Status
Not open for further replies.
GaDawg

GaDawg

Mechanical
Joined
May 27, 2003
Messages
22
Location
US
I am looking for a way to allow my Mitsubishi FX2N PLC to link to a BACnet network (and/or LonWorks). I have found plenty of protocol converters but either the serial protocol does not match or networking format is not compatible. Does anyone have experience with this or know where I might go to find a solution?

Thanks.
 
Status
Not open for further replies.

Similar threads

T
  • Question Question
translation table Modbus -BACnet
Replies
3
Views
14K
toninocp
T
Azam1985
  • Locked
  • Question Question
how to make Wibu dongle backup
Replies
0
Views
654
Azam1985
Azam1985
Lucianmwm
  • Locked
  • Question Question
Power and temperature oscillation, between Power range 55% to 75%, CAT CG260/16
Replies
0
Views
745
Lucianmwm
Lucianmwm
Kevin8686
  • Locked
  • Question Question
Sematic HMI 1st Generation KTP400 Basic Mono NP Migration to 2nd Generation KTP 400 Basic.
Replies
1
Views
818
Crowbar1
Crowbar1
vivekigles
  • Locked
  • Question Question
Need to set a pre loaded load cell value to zero in PLC.
Replies
1
Views
446
xnuke
xnuke

Part and Inventory Search

Sponsor

Back
Top