Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metric washer and lockwasher "J" standard?

Status
Not open for further replies.

CamoColton

Mechanical
Oct 13, 2008
4
US
Is there a "J" fastener part standard for Metric washers and lockwashers? There is a J2655 for Inch dimensioned washers but I am having no luck finding a similar standard for the metric.

Thanks for your help.
 
Replies continue below

Recommended for you

No, SAE canceled their automotive washer standard. SAE J2655 is from the Ship systems group. ASME B18.22.1 covers washers, but I think it is inch series as well. One of the ISO standards is probably your best option, e.g. ISO 10669, 10673, 7089, etc. Use the following link for more information:

 
The ISO standards are good ones. If you must have a US-based standard, try ASME B18.22M Metric Plain Washers.




Regards,

Cory

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor