Mesh through curves struggle

[TechnicalConsultant]

Please HELP! I am trying to model this using mesh through curve but can only seem to get it to create one section. any help very much appreciated.

Please see page 8 of this site for images.

http://cgi.mysite.wanadoo-members.co.uk/

Thank you!

 

[Xwheelguy]

Which is acceptable. You will have to use a point as a Primary string where there is not a 4th side on the two wireframe areas on either side of the initial surface.

Tim Flater
Senior Designer
Enkei America, Inc.

http://www.enkei.com

 

[TechnicalConsultant]

Thank you very much mate.Worked a treat,i knew i was missing something silly!
Much appreciated.