Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

machining plastic ABS POLYCARBONATE

Status
Not open for further replies.

pardal

Automotive
Joined
Oct 17, 2001
Messages
444
Location
AR
What are the specifications to drill and tap ABS and Polycarbonate???
The task to do is drill and tap 5/16 NC a trought hole about 10 mm thick.
Some pieces are just drilled and need only to tap.
Other are with no holes so I think to use a drill-tap tool.
I need to known
Cuting speed .
Tap and drill material
Its cuting angle and flutes.

RPM
Drill Feeding

Thanks in advance.






Pardal
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top