Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

.M & .M1 in PC-DMIS Dataview Report

Status
Not open for further replies.
jmarkus

jmarkus

Mechanical
Joined
Jul 11, 2001
Messages
377
Location
CA
What does .M and .M1 refer to in a PC-DMIS dataview report? I thought they were surface profiles, but when I compare back to the drawing the point and tolerance appear to be true position - but .TP is also reported.

Thanks,
Jeff
 
Status
Not open for further replies.

Similar threads

Joel_Lapointe
  • Locked
  • Question Question
Attribute gage r&r
Replies
2
Views
2K
3DDave
3DDave
Qcprick63
  • Locked
  • Question Question
GD&T Question
Replies
3
Views
343
Qcprick63
Qcprick63
RogerSAM
  • Locked
  • Question Question
Repair against Chloride SCC in Tank
Replies
5
Views
5K
SJones
SJones
PetkovStoyan
  • Locked
  • Question Question
Inspection of keyway in bore
Replies
13
Views
2K
geesaman.d
geesaman.d
mechengineer
  • Locked
  • Question Question
Quolifying thickness reducetion for forming head of pressure vessel in fabrication
Replies
2
Views
1K
david339933
david339933

Part and Inventory Search

Sponsor

Back
Top