Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

.M & .M1 in PC-DMIS Dataview Report

Status
Not open for further replies.
jmarkus

jmarkus

Mechanical
Jul 11, 2001
377
What does .M and .M1 refer to in a PC-DMIS dataview report? I thought they were surface profiles, but when I compare back to the drawing the point and tolerance appear to be true position - but .TP is also reported.

Thanks,
Jeff
 
Status
Not open for further replies.

Similar threads

Joel_Lapointe
  • Locked
  • Question
Attribute gage r&r 1
Replies
2
Views
2K
3DDave
3DDave
Qcprick63
  • Locked
  • Question
GD&T Question
Replies
3
Views
261
Qcprick63
Qcprick63
RogerSAM
  • Locked
  • Question
Repair against Chloride SCC in Tank 1
Replies
5
Views
5K
SJones
SJones
PetkovStoyan
  • Locked
  • Question
Inspection of keyway in bore
Replies
13
Views
1K
geesaman.d
geesaman.d
mechengineer
  • Locked
  • Question
Quolifying thickness reducetion for forming head of pressure vessel in fabrication
Replies
2
Views
1K
david339933
david339933

Part and Inventory Search

Sponsor

Back
Top Bottom