The information on lubrication of stainless screws was very informative. I have a question as to turning components. Close tolerance with a gap of 0.0003". At temperatures up to 600 deg. F, would the same lubricating materials be useful? Or would a coating such as Titanium disulfide be a good match. What are your thoughts?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lubrication of sliding components
- Thread starter Dtuck
- Start date
MikeHalloran
Mechanical
How many revolutions in how little time?
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
- Thread starter
- #3
MikeHalloran
Mechanical
I'm a big fan of Never-Seez and C-5A.
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question