JTWATER
Civil/Environmental
- Jun 2, 2014
- 1
Hi, I wanted to ask if anyone had information about the location of the screw conveying for a TBM. What is the difference, if any, between:
• locating the screw conveyor intake at the bottom of the cutterhead pressure chamber
• locating the screw conveyor intake at the center
are there disadvantages or advantages? Any information or documents you can share regarding this issue would be appreciated.
• locating the screw conveyor intake at the bottom of the cutterhead pressure chamber
• locating the screw conveyor intake at the center
are there disadvantages or advantages? Any information or documents you can share regarding this issue would be appreciated.