little help on patterns

[vikas02121]

hi,

i m a pro/e novice and i m mailing for the first time.

I have a problem in making a pattern.

Actually , i m trying to make a pattern(angular) of the cylinder on the top of a circular disc but till now i m unsuccessful.

but i created a pattern of hole on the disc successfully.

plz help me out of it



thanx

vikas

 

[kho131163]

Dear Vikas02121

Please take a look on the Pro on line help site - look at pattern - all informations are averrible and easy to understand



It

 

[prav2uin]

i have just started to learn pro/e. also i am learning ansys and ideas software.please help me about BOM

 

[adicar01]

Ok, I will send for u one file.

Read the help, Any kind of help.

and ... try-try-try.

 

[adicar01]

Ok, I will send for u one file.

Read the help, Any kind of help.

and ... try-try-try.

 

[adicar01]

OK, I make a file for you, I think will help you.



adicar01

 

[Rajesh]

After creating the feature to be patterned, use the copy command and rotate it with reference to the axis with which you want to pattern - independent option. Then delete the original. Now pattern this copied feature using the an angle value which was created when you copied.

Regards,

Rajesh S

 

[Rajesh]

After creating the feature to be patterned, use the copy command and rotate it with reference to the axis with which you want to pattern - independent option. Then delete the original. Now pattern this copied feature using the an angle value which was created when you copied.

Regards,

Rajesh S

 

[dougr]

Use the make-datum option to establish your pattern dimension (even if it's zero).



Word to the wise, never put your pattern dimension into your sketch....