Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Limits a Fits 1
- Thread starter dzupfrg
- Start date
-
1
- #2
JohnRBaker
Mechanical
When creating a Cylindrical dimension, whether you get an uppercase letter tolerance for a hole or a lowercase letter tolerance for a shaft, depends on the 'Type' option in the Settings dialog, as shown below (and in the attached image):
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Thread starter
- #4
MattBaumann
Mechanical
Why isn't the "type" option available in the dimension dialog box? This would make it so much easier to switch back and forth.
Also, is there a way to change how the tolerance is displayed? It is currently 10H7(0.015/0) where the H7 is always first. Is there a way to change it to put the H7 after the tolerance in parentheses? It currently doesn't match our long standing drafting standards.
Also, is there a way to change how the tolerance is displayed? It is currently 10H7(0.015/0) where the H7 is always first. Is there a way to change it to put the H7 after the tolerance in parentheses? It currently doesn't match our long standing drafting standards.
- Status
Similar threads
- Locked
- Question
- Locked
- Question