Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Library Feature Problem

Status
Not open for further replies.

Creigbm

Mechanical
Joined
Aug 1, 2003
Messages
161
Location
US
I am creating a library feature and it will not allow me to add a helix to the library. Has anyone encountered this before? If so, is there a work around or fix? I checked to make sure that I didnt have external references that may cause the problem, but I got no where. Thanks for your help

Brian
 
The only reason why I think it won't work, is because it's not a true sketch nor a feature. try making a second profile and sweep them together. That should then you could have the user remove the feature and the second profile. They would then be left with just the helix.

Regards,

Scott Baugh, CSWP [borg2]
CSWP.jpg

faq731-376
 
That is what I started out with. I had my loft created using two profiles and a helix and it would not let me add it to the library. Then I started investigating why and found I was unable to add the helix sketch to the library.
 
Do I go through my VAR to do this or straight through SW
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top