Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Laser drilling aspect ratio and tapering?

Thread starter antknee
Start date Oct 6, 2010

Status: Not open for further replies.

Oct 6, 2010

antknee

Mechanical

I'm trying to understand the aspect ratio when laser drilling. I will be using an ND Yag for drilling an entry diameter of 20 microns and I know the hole will get smaller as it drills through about 0.2mm thickness.

How can I calculate what the exit diameter will be?

Thanks,

Ant.