Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

large diameter chamber seal

Status
Not open for further replies.

engrnick

Mechanical
May 19, 2010
49
I'm tasked with designing a large diameter seal for a chamber that needs to be opened quickly by operators.

I've been looking at designs like those on autoclaves (the red round design):

I think this style works best, does anyone else have any other ideas?

Pressure is 60 psi, diameter is about 27inches.

I'm assuming that i can put a small taper on each of the teeth to help form compression. I'd appreciate it if you can give me any tips regarding the design of this.

Thanks!
 
Replies continue below

Recommended for you

I need to know more operating conditions. Media and temperature. I would suggest a spring energized seal or a simple rubber O-Ring. Like I said it depends on temperature range and media.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor