Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

lapping of stirrups in beams-inconsistencies

Status
Not open for further replies.
kww2008

kww2008

Structural
Joined
Feb 1, 2008
Messages
149
Location
AU
Does anyone notice the inconsistencies in the different standards relating to the lap length required for stirrups ? AS5100 requires 1.3 L_sy.t plus a hook at both ends of the lap, AS3600 requires 1.3 L_sy.t and AASHTO LFRD requires 1.7 L_d.
 
Status
Not open for further replies.

Similar threads

James_Gleeson
  • Locked
  • Question Question
Design of Flat Plate Beams to AS4100
Replies
10
Views
1K
Agent666
Agent666
DALOB
  • Question Question
AS3990 Maximum Permissible Stresses in Snug Tight Bolts
Replies
1
Views
488
Smoulder
Smoulder
Tomfh
  • Question Question
Revised internal pressure calculation in AS/NZS 1170.2:2021 Part 2
2
Replies
29
Views
29K
rowingengineer
rowingengineer
sdz
  • Locked
  • Article Article
OVERTURNING WIND LOADS ON CIRCULAR TANK ROOFS Centroid of Zone A
Replies
0
Views
1K
sdz
sdz
Rav01
  • Locked
  • Question Question
AS 3600 Cl 10.8 Transmission of Axial Force through floor systems
Replies
10
Views
2K
li0ngalahad
li0ngalahad

Part and Inventory Search

Sponsor

Back
Top