Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

lapping of stirrups in beams-inconsistencies

Status
Not open for further replies.
kww2008

kww2008

Structural
Feb 1, 2008
149
Does anyone notice the inconsistencies in the different standards relating to the lap length required for stirrups ? AS5100 requires 1.3 L_sy.t plus a hook at both ends of the lap, AS3600 requires 1.3 L_sy.t and AASHTO LFRD requires 1.7 L_d.
 
Status
Not open for further replies.

Similar threads

James_Gleeson
  • Locked
  • Question
Design of Flat Plate Beams to AS4100
Replies
10
Views
960
Agent666
Agent666
DALOB
  • Question
AS3990 Maximum Permissible Stresses in Snug Tight Bolts
Replies
0
Views
121
DALOB
DALOB
sdz
  • Locked
  • Article
OVERTURNING WIND LOADS ON CIRCULAR TANK ROOFS Centroid of Zone A
Replies
0
Views
1K
sdz
sdz
li0ngalahad
  • Locked
  • Question
AS3600 cl 11.2.1 vs 11.7.3 - Two Layers fo reinforcement in walls
Replies
4
Views
4K
li0ngalahad
li0ngalahad
Rav01
  • Locked
  • Question
AS 3600 Cl 10.8 Transmission of Axial Force through floor systems
Replies
10
Views
1K
li0ngalahad
li0ngalahad

Part and Inventory Search

Sponsor

Back
Top Bottom