Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is it possible to model inlet spread in HydroCAD?

Status
Not open for further replies.

ADube

Civil/Environmental
Joined
May 17, 2023
Messages
1
Location
US
As the title suggests, I'm looking for a way to model inlet spread in HydroCAD. The absence of info about how to do this suggests that the software isn't capable. Would you agree?

Thanks in advance!
 
I assume you're referring to flow width at a grate inlet? You could use a segment of channel flow to model the gutter.


Peter Smart
HydroCAD Software
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top