Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
In NX8 drafting, Dimension with arrows out does not show dimesnion lines
- Thread starter ptbkev04
- Start date
Arkance/PhoeNX
Mechanical
It can only be controlled in the customer defaults, so it will only be affected for new drawings.
See image for where in the customer defaults.
Anthony Galante
Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
See image for where in the customer defaults.
Anthony Galante
Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
JohnRBaker
Mechanical
While it might be true that you cannot edit the existing dimensions, you can change to a new or updated Drafting standard by going to Customer Defaults, make your changes to your standard, and save the Customer Default changes, log off and restart your session. Now with the Drawing open, go to...
Tools -> Drafting Standard...
...and simply select the Drafting Standard of interest, and hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
Tools -> Drafting Standard...
...and simply select the Drafting Standard of interest, and hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status