I am doing a thermal analysis of an assembly using COSMOS DesignStar 3.0. The model meshes with no errors, but when I run the analysis I get a message that says "Improper mesh near element 16842". There is no visual indication of where the failure is located in the model. Is there a way to determine the location of element 16842 in the model? Does anyone have a suggestion of what to look for when you get this error message?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Improper mesh
- Thread starter lwagner
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question