Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Importing survey points

Status
Not open for further replies.

cwong

Civil/Environmental
Feb 20, 2003
4
US
Hi,

I'm trying to convert an ascii file to binary using "DTMTools Extract XYZ" in Geopak, so that a tin file can be plotted.
However, the ascii file contains too many points (>70,000), and there is a limitation to the number of points using "DTMTools Extract XYZ". Instead of dissecting the large file into small ones (Excel has a limitation of 65536 rows), does anyone know of any other efficient ways to deal with this problem?

Would ACAD do the task? Macro? MDL? AutoLISP?

Thanks for the advice.
 
Replies continue below

Recommended for you

I'm not sure about MicroStation, but in AutoCAD .... this is a simple task.

See thread555-45632.

I hope that helps.
R. [spin]
 
Thanks! rKeytek.
That works well.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top