Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to apply channel matrix to a signal

Status
Not open for further replies.
milosm

milosm

Electrical
Feb 6, 2008
1
Hi there,

i found a MATLAB code that generates the 5-d wireless channel matrix. i was wondering how can i apply this generated matrix to a signal and observe the effect it has on the same.

any comments would be very much appreciated.

regards,

milos
 
Status
Not open for further replies.

Similar threads

T
How do I change a measurment unit in a Simscape custom block?
Replies
0
Views
2K
tamsou
T
AitorKo
  • Locked
  • Question
Work in Matlab with a reduced model in Abaqus
Replies
1
Views
1K
GVDR
G
TEIF-RO
  • Locked
  • Question
How to do a reccurent substitution in a symbolic matrix in matlab withor the ''FOR'' loop?
Replies
4
Views
895
GregLocock
GregLocock
VL_Narayanan
  • Locked
  • Question
How to interface SIMULINK model to modeFRONTIER
Replies
2
Views
286
GregLocock
GregLocock
Jef92
  • Locked
  • Question
Understanding how to set MTPA Reference block settings
Replies
0
Views
162
Jef92
Jef92

Part and Inventory Search

Sponsor

Back
Top Bottom