Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

High strength bolt installation question

Status
Not open for further replies.

OoReFLuXoO

Structural
Joined
Nov 17, 2014
Messages
3
Location
DE
A new building is going up. I'm looking at the bolting of the structure. They are A325TC bolts and A490.

When they install them, are they required to have the nut identification markings on the outside of the connection?

Is that in the ASTM book? I'm looking now and haven't run across it yet. Any guidance would greatly be appreciated! Thanks in advance!!
 
Look at the RCSC specification. It's a free download from This document covers installation methods and requirements. I do not believe there is any requirement regarding orientation of the nut to read the markings.
 
Bolt Head should be marked with Makers mark, ID (AA325TC or A490TC) and Nut/Washer marked as well. Connection requirements should be noted on erection plans. also check notes and local regs for inspection requirements -Observation, Skidmore qualification of bolts and bolting gun(s, etc. Minimal requirements for inspector are ICC S-1.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top