I have the challenge of characterizing the output flow from an intake and duct system across electrical boards. There is only about a half inch of room to measure the flow on the end of the boards, and i have been trying to use a hot wire anemometer. The values fluctuate irradictly due to the turbulant nature of the flow. Does anyone know if channeling the air through something to then take a measurement would then give me a false value from the averege value.?????
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fluid Flow Analysis Techiniques
- Thread starter JS24SLP
- Start date
Similar threads
- Question
- Locked
- Question