Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

fill in reference

Status
Not open for further replies.
angy11

angy11

Geotechnical
Apr 11, 2005
3
Is it possible to turn fill off only in reference fail?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
No, it is controlled by view attributes which are global to a design file.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

darcy1942
  • Locked
  • Question
Using the middle mouse button to pan/drag and tentative snap + left click in one step
Replies
1
Views
2K
udraft
udraft
davidinindy
  • Locked
  • Question
Saving a Solidworks file into a .DGN file without any Bently / Microstation software?
Replies
1
Views
653
JG2828
JG2828
CWEngineer
  • Locked
  • Question
Scale for Cells in Microstation V8i vs J
Replies
0
Views
533
CWEngineer
CWEngineer
Sn00ze
  • Locked
  • Question
DWG block attributes into DGN
Replies
0
Views
458
Sn00ze
Sn00ze
GhostsOfCanton
  • Locked
  • Question
In-Roads: Vertical alignment "disappearing" when inserting a PI
Replies
0
Views
479
GhostsOfCanton
GhostsOfCanton

Part and Inventory Search

Sponsor

Back
Top Bottom