Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fiberglass Mold Fabrication.

Status
Not open for further replies.
joroke

joroke

Structural
Joined
Feb 25, 2003
Messages
1
Location
US
I work for a water slide company and we are trying to figure out were to have our molds fabricated. The molds are utilized to create fiberglass parts. The molds are usually less then 10' in length and 5' in width.
Any information of possible mold fabricators or experiences would be greatly appreciated.
 
Status
Not open for further replies.

Similar threads

clyde Verse
  • Locked
  • Question Question
Any way to produce a 100% same plastic lampshell without injection mold?
Replies
5
Views
1K
Pud
Pud
Buckshott00
  • Locked
  • Question Question
Process Setting for Improved Over-molding to prevent delamination In Molded Hytrel
Replies
0
Views
967
Buckshott00
Buckshott00
cityjack
  • Locked
  • Question Question
Mold program to 3D model. How?
Replies
0
Views
244
cityjack
cityjack
titan0106
  • Locked
  • Question Question
unidentified liquid rsidual on the surface of connectors (PA66+30GF injection molded)
Replies
1
Views
972
Pud
Pud
Sold5
  • Locked
  • Question Question
Factory Acceptance Tests for injection molds
Replies
6
Views
1K
stebro Mold
stebro Mold

Part and Inventory Search

Sponsor

Back
Top