Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

feed pump trip? 4

Status
Not open for further replies.

saadati

Mechanical
Joined
Dec 1, 2011
Messages
2
Location
US
Protection pressure feed pumps in power plants, because there? Feed pump output pressure is low because the trip?
 
Please ask someone to help you reword the question. We cannot understand what you are asking.

Johnny Pellin
 
In power plant why The main feed pump trip on low suction pressure?
 
To prevent the pump to run dry - without any water in it.
 
Low pressure at the suction side of a pump can encounter the fluid to start boiling with

•reduced efficiency
•cavitation
•damage

of the pump as a result. Boiling starts when the pressure in the liquid is reduced to the vapor pressure of the fluid at the actual temperature.

 
The pump has been selected to run with correct suction pressure, any reduction of pressure can cause damage, therefore suction pressure is monitored and will trip if low.

or

suction pump run pressure correct to low trip for damage with

It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top