Feature Manager Problem 1

[MachineSMMC]

Good Morning

When in sketch mode, I use to be able to select two lines and the properties manager would come up so I could add a constraint. Now it stays on the feature manager design tree. Anybody else ever see this? How do you correct it.

Thanks
Chris

 

[handleman]

Go to Tools->Options, on the System Options tab, choose the "General" category. Second check-box from the bottom is "Auto-Show Property Manager". Check this box.

 

[MachineSMMC]

That did the trick. Don't remember unchecking it.

Thanks
Chris

 

[dgowans]

Who else experiences mysterious option settings getting changed like that? I see this from time to time and am always stumped as to how that happens. I so rarely go into the options after an initial install that I'm sure settings occasionally get changed randomly.

Either that or my meds are wearing off.........

 

[CycloneWade]

Diddo...I uped my meds.

 

[brengine]

I have seen various Tools/Options settings randomly change from time to time.

Ken

 

[pgp001]

The one that I notice dissapearing the most is the 'Display/Selection' - 'Dynamic Highlight From Graphics View' took a while to figure out what had happened, it seems pretty random as well.

Phil