Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fanuc Memory card for RJ2 controller 1

Status
Not open for further replies.

roland7800

Automotive
Joined
Nov 27, 2006
Messages
2
Location
PL
Hello
I’m looking for a memory card for Fanuc RJ2 controller to do backups and change data between robot and Pc.
Does any body know how can i sell this card?
Thanks !
roland
 
Fanuc can sell you their DOS-based program called "KFLOPPY". It is a floppy drive emulator. Connect your PC to RJ2 via RS232 cable and transfer files.

TygerDawg
 
Thanks TygerDawg
I work with the "Kfloppy", the problem is the data save takes a long time, i have 82 old robots to program. Normal PCMCIA card works only up to RJ3, yes i can by the special PCMCIA card by fanuc, but that cost me 400$.
greet from Austria
roland
 
I have an RJ Controller. How do I start the process to load SpoTTool onto the RJ controller. I have the KFLoppy software and SpotTool image but no documentation on how the start the transfer process. It is different from the menus given for a RJ2 controller.

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top