U
Uni Phil
Guest
Hi All
I have a suspension shock which is a standard part but comes in many different lengths. Essentially it is just the shaft that changes and instead of saving a model for every length from eye to eye and stroke length is it possible to set up a family table.
At the moment i restrict the +/- stroke movement by setting a jt axis setting in mechanism so that you can only pull and push it out a given stroke length.
Is there a way of pulling in the jt axis setting into a family table?
Any help would be much apprciated.
I have a suspension shock which is a standard part but comes in many different lengths. Essentially it is just the shaft that changes and instead of saving a model for every length from eye to eye and stroke length is it possible to set up a family table.
At the moment i restrict the +/- stroke movement by setting a jt axis setting in mechanism so that you can only pull and push it out a given stroke length.
Is there a way of pulling in the jt axis setting into a family table?
Any help would be much apprciated.
