Angle analysis feature to be used as a dimension in a drawing table

[taraskaz]

Could someone tell me how can I create such kind of angle analysis as on the attached images? The aim is to measure an angle between two planes and then to use it in a dimension in a drawing table.
View attachment 6876View attachment 6877

 

[annad_m_s]

Create a user defined parameter with a name of your preference and assign the value of the measured angle using this syntax:
XXX=angle:FID_ANALYSIS_ANGLE_1 where XXX is the user defined parameter, "angle" is the system parameter created within the analysis feature "ANALYSIS_ANGLE_1".
Then use this parameter in the drawing by referring this parameter as &XXX in the table.