Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

fabricators of pressure vessels? 3

Status
Not open for further replies.

cmn8226

Mechanical
Joined
Apr 2, 2007
Messages
32
Location
US
Anyone know any shop with ASME certification (with radiographic, LP, WPS/PQR, etc etc)that can fabricate pressure vessels? specifically Static mixers from carbon steel and stainless steel. Its gotta be in the Houston, TX area.
 
There should be no end of them down there- tried the yellow pages?
 
thanks christine,

when you say U stamp, it takes me to exactly what I need. perfect.
 
I will say good luck. Due to the fact that industry is booming, it's mighty hard to get shop floor time in most PV shops in Houston these days. If you have a lot of lead time, then probably no problem. Again, good luck!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top