Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

extruded solids' resolution

Status
Not open for further replies.

viderde

Mechanical
Joined
Apr 27, 2012
Messages
6
Location
US
Is there a setting that allows me to change the resolution (not sure if that is even the correct terminology) of an extruded solid? When you extrude a sketch, the solid extrusion is not as smooth as the actual sketch. An example of this is in the picture attached. The light blue line is the sketch, and you can see the solid not exactly how the sketch is drawn.

This isn't a big deal when you are dealing with large parts, but I find it annoying when I am working with very small parts and zoom in and it looks different than how it should be.
 
The setting you are looking for is Accuracy.
All solid modelers use a faceted surface display to speed up rendering time. You can reduce the chord lengths by trial and error. If you are zoomed in that tight on your drawing views that it shows, then you need to adjust it. The one thing you can do is move the sketch entity to a different layer than the solid and blamk the sketch layer.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
View/display settings/model display

On the Edge/Line tab change edge quality to very high. You might want to select the smooth line option too.

On the Shade tab set the quality to 10.

Note that these settings may slow your system response.

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top