Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Extend Line Display

Status
Not open for further replies.
ratm375

ratm375

Mechanical
Joined
Sep 26, 2005
Messages
4
Location
US
I know when I started using Microstation, the display (coordinate readout) showed the total length of the line I was extending. Now, because of some change, it shows the distance from the end of the line I'm extending. Where do you go to change this?
 
Sort by date Sort by votes
I think you are talking about accudraw here? You can go under accudraw settings and make sure you have context sensitivity on.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

GhostsOfCanton
  • Locked
  • Question Question
MOVE circle tangent to two lines.
Replies
0
Views
654
GhostsOfCanton
GhostsOfCanton
GhostsOfCanton
  • Locked
  • Question Question
Drawing Line in Microstation with Relative Coordinates using Distance and Percent Slope
Replies
1
Views
722
mechamb
mechamb
JunCivil
  • Locked
  • Question Question
Run macro to draw lines?
Replies
2
Views
451
JunCivil
JunCivil
deano281
  • Locked
  • Question Question
Cells not displaying in referenced files??
Replies
6
Views
985
mechamb
mechamb
dkleinot
  • Locked
  • Question Question
Best fit line through points
Replies
1
Views
569
mechamb
mechamb

Part and Inventory Search

Sponsor

Back
Top