I have been using the newer version of Enercalc (version 6) for a variety of designs. I noticed when using the masonry wall design module that some of the results didn't look correct. The axial stress and calculated deflections look much higher than calculated using rough hand calcs. Has anybody else experienced this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Enercalc Masonry Slender Wall
- Thread starter bgsmith
- Start date
Similar threads
- Question
- Question
- Question
- Question
