thejackal3
Automotive
We do induction heat treatment of axle shafts made of EN8D and then furnace temper it.Axle shafts are 58-62 HRC as quenched.for how much time and at what temperature we temper them to get 55-56HRC on surface?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
EN8D axle shafts temper time
- Thread starter thejackal3
- Start date
- Status
- Thread starter
- #3
thejackal3,it will,help,if you provide your thermal cycle details in the initial post,rather than providing them after someone responds. This will avoid wastage of time and discussions . Also,it will generate more meaningful response.
_____________________________________
"It's better to die standing than live your whole life on the knees" by Peter Mayle in his book A Good Year
_____________________________________
"It's better to die standing than live your whole life on the knees" by Peter Mayle in his book A Good Year
- Status
Similar threads
- Question
