Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drills For CFRP

Status
Not open for further replies.
MSSandvik

MSSandvik

Materials
Joined
May 24, 2010
Messages
9
Location
SE

Does anyone know if there are any standard drill point geometries for CFRP drilling?

By this i mean NAS 907 describes some drills and the metals they're to be used on. Is there one for CFRP?

Any help appreciated
 
Sort by date Sort by votes
rerig

Nice one, this looks good.

I assume the ST10-907-A is a NAS 907 A point geomtery?

Thanks for your help.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

crostolo
  • Locked
  • Question Question
Inserts in Thick CFRP Panels
Replies
2
Views
566
crostolo
crostolo
Ryan_aero
  • Locked
  • Question Question
Increasing Bearing Strength Locally at a Few Fasteners for CFRP Double Shear Joint
Replies
5
Views
573
Ryan_aero
Ryan_aero
vinguy
  • Locked
  • Question Question
Compressed Air vs Nitrogen for Autoclave Cures
Replies
5
Views
2K
georgeverghese
georgeverghese
Cisnerjo
  • Locked
  • Question Question
Plaster Mandrels alternative materials for washout mandrels (fiber glass air ducts)
Replies
2
Views
986
Cisnerjo
Cisnerjo
Burner2k
  • Locked
  • Question Question
Defect Characterization for NDT
Replies
2
Views
750
WKTaylor
WKTaylor

Part and Inventory Search

Sponsor

Back
Top