Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drills For CFRP

Status
Not open for further replies.
MSSandvik

MSSandvik

Materials
May 24, 2010
9

Does anyone know if there are any standard drill point geometries for CFRP drilling?

By this i mean NAS 907 describes some drills and the metals they're to be used on. Is there one for CFRP?

Any help appreciated
 
Replies continue below

Recommended for you

Sort by date Sort by votes
rerig

Nice one, this looks good.

I assume the ST10-907-A is a NAS 907 A point geomtery?

Thanks for your help.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

crostolo
  • Locked
  • Question
Inserts in Thick CFRP Panels
Replies
2
Views
396
crostolo
crostolo
Ryan_aero
  • Locked
  • Question
Increasing Bearing Strength Locally at a Few Fasteners for CFRP Double Shear Joint
Replies
5
Views
377
Ryan_aero
Ryan_aero
vinguy
  • Locked
  • Question
Compressed Air vs Nitrogen for Autoclave Cures
Replies
5
Views
2K
georgeverghese
georgeverghese
Cisnerjo
  • Locked
  • Question
Plaster Mandrels alternative materials for washout mandrels (fiber glass air ducts) 1
Replies
2
Views
789
Cisnerjo
Cisnerjo
Burner2k
  • Locked
  • Question
Defect Characterization for NDT
Replies
2
Views
589
WKTaylor
WKTaylor

Part and Inventory Search

Sponsor

Back
Top Bottom