rodrigomanera
Structural
Hello,
I would like to know the way to assign a variable distributed load to a shell element?
I would like to know the way to assign a variable distributed load to a shell element?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Distributed Load - SHELL
- Thread starter rodrigomanera
- Start date
- Status
Dear rodmanera,
you should do the following:
Go to:
Define/Joint pattern/Add new...
Select the shell you want to load, and the go to:
Assing/Joint pattern/
Select the Joint pattern name and specify the function you want for the load (in global axes). Then go to:
Assing/Area loads/Surface Pressure/Click on "by joint pattern"
Select the joint pattern you used before, and the multiplier. Best regards,
Sebastian
you should do the following:
Go to:
Define/Joint pattern/Add new...
Select the shell you want to load, and the go to:
Assing/Joint pattern/
Select the Joint pattern name and specify the function you want for the load (in global axes). Then go to:
Assing/Area loads/Surface Pressure/Click on "by joint pattern"
Select the joint pattern you used before, and the multiplier. Best regards,
Sebastian
- Status
Similar threads
- Question