Looking for recommendations on filler metal for welding 317L stainless to SA516-70 for a 650 deg F application. Typically use 309 for carbon to stainless joints, but would like to make sure that this particular dissimilar joint doesn't pose any additional issues.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Dissimilar welding of 317Lss (P-8) to SA516-70 (P-1)
- Thread starter weldgal
- Start date
EdStainless
Materials
Given the higher Mo content of 317L the use of the Ni-Cr-Mo fillers would be a good idea.
= = = = = = = = = = = = = = = = = = = =
Rust never sleeps
Neither should your protection
= = = = = = = = = = = = = = = = = = = =
Rust never sleeps
Neither should your protection
- Status
Similar threads
- Locked
- Question
- Locked
- Question